Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

High mount brake shaft!!!!

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 59
Joined: Thu May 10, 2007 3:31 pm
Location: Geelong

High mount brake shaft!!!!

Post by chpd 80 »

Need to remove brake shaft from high mount to put in drilled and
tapped shaft.
What is the easiest way to get shaft cap and shaft out.?

Was planning on hammer and brass punch, but am having trouble
getting the inside cap off before punching out the shaft :x

Any ideas??

ps. the cap I'm talking about is one on the drum/motor side of the housing.
What could possibly go wrong????
Top
Posts: 417
Joined: Wed Jul 13, 2005 8:30 pm
Location: NSW

Post by Modified Toy »

inside there is a piece of steel that locks it in remove that and it should slide out with some assistance as you need to push the seal out aswell.
Top
Posts: 59
Joined: Thu May 10, 2007 3:31 pm
Location: Geelong

Post by chpd 80 »

Thanks heaps mate, now I know how it works. Pressed off steel
ring and shaft came straight out, no need to get end cap off.

Thanks again.
What could possibly go wrong????
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 2 guests