Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

how to remove needle bearing from stub axle

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Post Reply
Posts: 250
Joined: Sat Sep 20, 2003 1:01 am
Location: sydney

how to remove needle bearing from stub axle

Post by alki »

I've taken front end apart to do swivel hub seals and needle bearing is not budging.
What do you guys use to remove that bearing?
GU III,3.0 di
Posts: 2601
Joined: Tue Jul 13, 2004 8:02 pm
Location: warner, brisbane

Post by chunderlicious »

a screwdriver and a hammer
turbos are nice but i'd rather be blown
Posts: 129
Joined: Sun Jun 29, 2008 4:10 pm
Location: Melbourne, Victoria, Australia

Post by striga22 »

is it the one inside the stub where the cv goes thru?
need some plumbing done? cashies top quality job for cheaper south east melbourne Daniel 0423771198
Posts: 32
Joined: Thu Nov 25, 2004 8:56 pm
Location: Geelong, Victoria

Post by Fox Shooter »

What I did was use a Dremel with a thin cut off wheel ( 25mm across and about .6mm thick ). I cut a grove across the inner race just being careful not to go all the way through. Then used a hammer and cold chisel in the grove to split the inner race open, this will make it very easy to slide off.

Just remember to use safety glasses and bearings are case hardened and can shatter.
Posts: 33
Joined: Thu Dec 25, 2008 5:51 pm
Location: mackay

Post by TempesT »

this fell into the too hard basket for me when the inner lip sheared off. Took it to the locat 4x4 guys and they poped it off and put the new one in. 5min of their time. :armsup:

jim
Post Reply

Who is online

Users browsing this forum: No registered users and 7 guests