I've taken front end apart to do swivel hub seals and needle bearing is not budging.
What do you guys use to remove that bearing?
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
how to remove needle bearing from stub axle
how to remove needle bearing from stub axle
GU III,3.0 di
What I did was use a Dremel with a thin cut off wheel ( 25mm across and about .6mm thick ). I cut a grove across the inner race just being careful not to go all the way through. Then used a hammer and cold chisel in the grove to split the inner race open, this will make it very easy to slide off.
Just remember to use safety glasses and bearings are case hardened and can shatter.
Just remember to use safety glasses and bearings are case hardened and can shatter.
Who is online
Users browsing this forum: No registered users and 22 guests