While trying to get those bloody shackle pins out, we popped the front slip joint.
If anyone could have a look at theirs (LN65) and advise on the alignment of the unis- ie the diff end and the cardon joint end- are the yokes in line or at 90deg to each other?
There was a vibration in the front shaft that felt awefully like a phasing problem (from previous owner- note we haven't had the truck very long) before we popped it.
Just want to get it right and any advice would be much appreciated!
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Hilux front tailshaft phasing
Moderators: toaddog, Elmo, DUDELUX
I work for a driveshaft company and we phase all shafts at zero degrees, ie. ears should line up as stated above. Except for commodore shafts which have different phasing depending on model. So yeah, put the slip back together so the ears line up, and if it feels like it vibrates heaps, take it apart again and turn it 180 degrees.
Hope this helps
Hope this helps
Who is online
Users browsing this forum: No registered users and 1 guest