Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Hilux front tailshaft phasing

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Post Reply
Posts: 13
Joined: Fri Dec 11, 2009 6:37 am
Location: Snowy Mountains NSW

Hilux front tailshaft phasing

Post by dug1 »

While trying to get those bloody shackle pins out, we popped the front slip joint.

If anyone could have a look at theirs (LN65) and advise on the alignment of the unis- ie the diff end and the cardon joint end- are the yokes in line or at 90deg to each other?

There was a vibration in the front shaft that felt awefully like a phasing problem (from previous owner- note we haven't had the truck very long) before we popped it.

Just want to get it right and any advice would be much appreciated!
Posts: 658
Joined: Wed Feb 13, 2008 5:41 pm
Location: Brissy

Post by yamaha__308 »

The ears should be inline.
Posts: 96
Joined: Wed Apr 18, 2007 1:20 pm
Location: Frankston

Post by smaddock »

I work for a driveshaft company and we phase all shafts at zero degrees, ie. ears should line up as stated above. Except for commodore shafts which have different phasing depending on model. So yeah, put the slip back together so the ears line up, and if it feels like it vibrates heaps, take it apart again and turn it 180 degrees.

Hope this helps
Posts: 13
Joined: Fri Dec 11, 2009 6:37 am
Location: Snowy Mountains NSW

Post by dug1 »

Thanks guys- much appreciated!
Posts: 337
Joined: Tue Jan 18, 2005 10:16 pm
Location: Gympie

Post by small talk »

Will it be the same for the rear shaft?
1984 Hilux dualcab.
Resident Terrorist
Posts: 4278
Joined: Fri May 21, 2004 9:37 am
Location: Driving Barnsey's mum to bingo

Post by RAY185 »

small talk wrote:Will it be the same for the rear shaft?
yep
Post Reply

Who is online

Users browsing this forum: No registered users and 49 guests