80series 4"lift + 36"et2 pics wanted

[udm]

Anybody got pics of 80series on 4" springs and 36" et2?

Just want to know if its a combination that dont work.

[Jeff80]

This my 80 on 35's with a 4 inch lift. From memory I had a 1inch spacer in at that stage as well, but have since removed it. There is plenty of room for 36's with just the 4 inch, no need for anything bigger.

[udm]

Always had the car on 6" springs, and got a set of 4" springs hanging around that i want to use now, so i was wondering if the 36" et2 i got would look weird on 4".

[80's_delirious]

I had 35" MTZs on my 80 with 4" lift with no clearance problems.

Wheel offset will play a part. standard offset shouldnt cause any problems

[ndog]

ull be sweet i have 35'' creepy crawlers on 2'' lift and only just scrubs at full flex

[TheBigBoy]

4" lift and 35 muddies.



You can run 15x10 steelies with a neg 44 offset (like in the pic) without any problems if you set up your panhard rod correctly with slightly off to 1 side. So both wheels tuck evenly.

[zookimal]

3+2+36 Ullises. How's things mate?

[udm]

Thanks guys for the effort, but i have already had 35" muddies before and know that they fit fine... its the 36" et2 which i am not convinced will fit well.

I think i am just going to start with the 4" springs and see how it goes.

This is how my previous cruiser sat with 6" + 36" et2, so i think small springs will only cause problems.

[udm]

3+2+36 Ullises. How's things mate?

All good mate... finally found a new car to replace the red one. What have you been up to?

[TheBigBoy]

Different tyre brands are different sizes for the same branded size. Ive found simex to be smaller and their 36" to measure out to the same as the 35'"s I had previously.

[Triple B]

hey mate. I got three to four lift plus two in the body running 36/13/16 swampers tsl. prevously a had 35 maxis mudzilers and found they are a fair bit smaller. i've done nothing to my bumps stops and get very little scrub. have found a rock getting between the wheels and gaurd once. my biggest issue i have is hitting my exhaust both front and back in the wheel arch. I personaly wouldn't like to run them without body blocks but. i guess there is allways a way.

[IMG]http://i740.photobucket.com/albums/xx50/tripleb_racing/stuff115.jpg[/IMG]
[IMG]http://i740.photobucket.com/albums/xx50/tripleb_racing/stuff115.jpg[/IMG]
[IMG]http://i740.photobucket.com/albums/xx50/tripleb_racing/stuff030.jpg[/IMG]




sorry not sure if the previouse pic will post, so these are a direct link to them.

http://i740.photobucket.com/albums/xx50/tripleb_racing/stuff115.jpg
http://i740.photobucket.com/albums/xx50/tripleb_racing/stuff030.jpg
http://i740.photobucket.com/albums/xx50/tripleb_racing/stuff081.jpg

[80's_delirious]