Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Wheel bearing lock washer question

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Post Reply
Posts: 24
Joined: Thu Jul 21, 2005 5:23 pm
Location: Brisbane

Wheel bearing lock washer question

Post by grassyknoll »

Hey guys, just doing the wheels bearing on the GQ with the lock nut upgrade (round ones). Just wondering if I keep the lock washer that goes up against the outer bearing, not the one between the old lock nuts (hex ones).

Cheers.
Posts: 42
Joined: Wed Apr 20, 2005 9:21 pm

Post by nalucas »

I'm certain I left mine on there when I did the conversion, but it's not actually a lock washer perse, it just engages with the shaft to stop it rotating from memory.

Hope that helps.

Nathan
Posts: 24
Joined: Thu Jul 21, 2005 5:23 pm
Location: Brisbane

Post by grassyknoll »

Cool, thx for the help :).
Posts: 1949
Joined: Wed Oct 23, 2002 7:44 am
Location: Melbourne, Australia

Post by MKPatrolGuy »

I left it in on mine too.
[size=100][url=http://www.vickrawlers.com/]VicKrawlers.com[/url]
[url=http://www.drfwdc.org.au/]Dandenong Ranges 4wd Club[/url][/size]
Posts: 1578
Joined: Wed Aug 31, 2005 12:27 am
Location: In The Good Country

Post by sudso »

I think the thin lock washer between the 2 original lock nuts is there to stop the second nut (while torquing it up) from causing the 1st nut to tighten more, otherwise you would increase the preload on the bearings.
Correct me if I'm wrong but I'd leave it there too.

cheers, sudso
Bordertrek 4X4 & Fabrication
0400 250 734 Bordertown SA
I love terra firma-the less firma the more terra
Post Reply

Who is online

Users browsing this forum: No registered users and 172 guests