Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
diesel engine cut off switch
Moderators: toaddog, TWISTY, V8Patrol, Moderators
diesel engine cut off switch
Just wont to no how and the best way to install a engine cut off switch 4 comp use in a hilux with a diesel in it thanks
Re: diesel engine cut off switch
remove or power (whichever way it works on your motor) the fuel cut solenoid through a relay and a switch. if it is for safety legalities i.e. cams, you may find it needs to be a mechanical cutoff and you will need to see the governing bodies rules on what needs to be cut off i.e. fuel, power, etc.
turbos are nice but i'd rather be blown
Re: diesel engine cut off switch
electric cutoff as you describe is perfectly acceptable for CAMS.
I use a two pole waterproof pushbutton switch. one pole cuts power to the fuel pump solenoid and the other pole cuts the ground wire off the Battery isolator solenoid.
reason for the two poles is the alternator will provide power to keep the fuel pump going if you cut the battery.
reason for switching ground on the solenoid is that a single wire is needed and the positive side of the solenoid gets power from a fuse holder across the terminals.
I use a two pole waterproof pushbutton switch. one pole cuts power to the fuel pump solenoid and the other pole cuts the ground wire off the Battery isolator solenoid.
reason for the two poles is the alternator will provide power to keep the fuel pump going if you cut the battery.
reason for switching ground on the solenoid is that a single wire is needed and the positive side of the solenoid gets power from a fuse holder across the terminals.
Who is online
Users browsing this forum: No registered users and 123 guests